- Pet smart GPS locatorActuonix PQ12-R Linear Actuator 20mm, 100:1, 6V, RC Control

• Actuonix PQ12-R Actuator 20mm, RC Control
• Input voltage: 6 VDC
• Peak power point: 40 N @ 6 mm/s
• Gear ratio: 100:1
• Max speed (no load): 10 mm/s
• Stall current: 550 mA

The PQ12-R Linear Actuator 20mm, 100:1, 6V, RC Control operates as a direct replacement for standard rotary servos. It uses the same standard 3 wires connectors, ground, power, and control. Regardless of how you drive your servos, driven with an RC receiver, an Arduino board, or a VEX micro-controller, the PQ12-R servo perfectly replaces a regular servo with the added benefit of providing linear motion.

The -R actuators are ideally suited to use in robotics and radio control models. They are a direct replacement for regular radio-controlled hobby servos. The desired actuator position is input to the actuator on lead 1 as a positive 5 Volt pulse width signal. A 2.0 ms pulse commands the controller to fully retract the actuator and a 1.0 ms pulse signals it to fully extend.

If the motion of the actuator, or of other servos in your system, seems erratic, place a 1–4Ω resistor in series with the actuator’s red V+ lead wire.

The PQ12–R Linear Servos are designed to work with typical RC receivers and battery packs. Consequently, they also are compatible with Arduino control boards, VEX Microcontrollers, and many other similar boards designed for robotics.